After troweling the entire surface, let the concrete dry a bit more.Don't worry if you're leaving a few small lines from the trowel, you will remove them on the next pass.Go over the same area 2 - 3 times and it will start to look smoother. Slightly tip the edge of the trowel up a bit in the direction you're moving it. Start troweling using the same back and forth motion as you did with the mag float.Once you've gone over the entire surface, let it dry a little before using your hand trowel.This motion will change the texture of the surface, working up some creme and cement paste. With moderate pressure, move the mag float in a back and forth motion. On your first finishing pass, use a mag float to smooth the surface.After pouring the concrete let the concrete firm up enough so you can only press your fingers into the surface about 1/4 of an inch.The basic steps for finishing concrete are: If you have a small concrete slab or floor and you want to achieve a smooth finish, using a steel trowel is going to be your best bet to finish the concrete.Ī hand trowel will give you a very smooth finish to the concrete if you know the proper procedure on how and when to start using it. I've been a concrete finisher for nearly 40 years and have extensive experience in all types of concrete finishing that I want to share with YOU! How to finish with a hand trowel That's what I'm going to provide you with. On this page I will go over how to finish concrete with the following techniques:įinishing concrete, whether your hand troweling or power troweling the concrete smooth or giving the concrete some texture with a broom or stamping, will require some type of experience or knowledge.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |